+ Post New Thread
Page 1 of 29 1 2 3 11 ... LastLast
Threads 1 to 20 of 573

Forum: Safety Issues

Questions and issues related to safety.

  1. Sticky Thread Sticky: Safety Forum Purpose

    This forum has been created as a result of several requests by those of us active in safety matters to have a special place where questions and...

    Started by Vince, 08-28-2002 03:28 PM
    • Replies: 0
    • Views: 2,965
    08-28-2002 03:28 PM Go to last post
  1. ** Propane tank OPD valve recall--PLEASE READ!! **

    **There's been a recall on 21,000 Propane Overfill Protection Devices (OPD valves).** Name of product: SCG Liquid Propane Overfill Protection...

    Started by Mag_Alef, 01-29-2004 09:49 AM
    • Replies: 1
    • Views: 1,084
    02-05-2004 04:55 PM Go to last post
  2. ...And then there was a loud bang

    A scary thing happened when I changed my propane tank and I was wondering if anyone could help me understand it. Just after I put the regulator...

    Started by gagedesigns, 10-12-2003 06:48 PM
    5 Pages
    1 2 3 ... 5
    • Replies: 44
    • Views: 3,200
    10-21-2003 11:54 AM Go to last post
  3. 02 tanks--Indoors vs. Outdoors?

    As I struggled yesterday for 20 minutes to get my smaller 02 tank up the stairs and into my schoolbus without injuring my back, and after watching...

    Started by margi, 11-08-2003 08:56 AM
    • Replies: 1
    • Views: 347
    11-08-2003 11:38 AM Go to last post
  4. 1 lb. Propane Canister

    I can obtain Mapp gas, but it presents some problems. I was thinking of trying Propane. Can I use a one pound cannister with my Hothead just to try...

    Started by artisand, 06-03-2004 03:09 PM
    • Replies: 3
    • Views: 736
    06-06-2004 01:52 AM Go to last post
  5. 100lb propylene tank? Is this safe??

    I have asked this question on two other forums and no one seems to have an answer. :( I made the call to my welding shop about picking up a 30lb...

    Started by StefaniBeads, 09-27-2006 12:06 PM
    • Replies: 1
    • Views: 590
    09-27-2006 08:38 PM Go to last post
  6. 1320 CFM attic fan question.

    Hello all i'm new here so go easy on me. My bench sits infront of a window i have a 1320 CFM small attic fan that will fit in the window, that should...

    Started by rudedogg, 03-08-2005 06:47 PM
    • Replies: 3
    • Views: 773
    03-08-2005 08:27 PM Go to last post
  7. A "class"

    I went this Saturday to the White Oak Gathering, a fur trade enactment site here in northern Minnesota. Among the many craft tents I was quite...

    Started by boesedon, 08-07-2004 05:17 PM
    • Replies: 4
    • Views: 732
    08-09-2004 02:59 AM Go to last post
  8. A few differnt questions

    Okay to start off, I am using a bobcat torch with propane and an oxy concentrator. I live in michigan and it gets kinda cold around here. I tried...

    Started by mystikmelo, 01-14-2005 11:10 PM
    • Replies: 3
    • Views: 635
    01-23-2005 04:09 AM Go to last post
  9. A Natural Gas Flash Back Arrestor???

    Hi! I have the gas guy here today setting up my minor torch to natural gas and a concentrator....the gas inspector wants a natural gas flash back...

    Started by wildwire, 01-21-2005 12:24 PM
    • Replies: 2
    • Views: 1,833
    01-21-2005 08:29 PM Go to last post
  10. A question about MAPP gas.....

    I am making the transition between a Hot Head torch and a Minor. I have been using mapp gas purchased in bulk cylinders. I still have about half a...

    Started by keysbeat, 08-21-2003 05:59 PM
    • Replies: 2
    • Views: 480
    08-21-2003 09:16 PM Go to last post
  11. A sense of appreciation...

    I just want to post here for the benefit of the numerous responders on the ISGB Safety Forum that at least 50 people have come to me during the...

    Started by Vince, 08-10-2003 12:26 AM
    • Replies: 5
    • Views: 532
    10-16-2003 02:26 PM Go to last post
  12. A twist on the propane question

    I think the position is fairly well established on having a tank propane inside a residence or attached garage\workshop. But - heres a whatif. ...

    Started by navarre, 01-22-2007 05:04 AM
    2 Pages
    1 2
    • Replies: 11
    • Views: 1,798
    01-25-2007 12:49 PM Go to last post
  13. Adult Blood Lead Epidemiology and Surveillance

    The CDC has published its annual report based on information collected by various states. During 2002, 35 states reported information of adult...

    Started by Vince, 08-07-2004 01:17 PM
    • Replies: 1
    • Views: 479
    08-12-2004 09:34 AM Go to last post
  14. Advice Please

    My "studio"(must use that word lightly in my case) is upstairs in my unfinished area. I have a BBQ size tank of MAPP gas. My husband,firefighter,...

    Started by Josie, 09-02-2002 06:18 PM
    • Replies: 6
    • Views: 1,196
    09-12-2002 12:20 PM Go to last post
  15. Air cleaners

    Hello, I was wondering if anyone knew what type or size of micron filter it would take to clean the vapors (gold silver etc) from the air exiting...

    Started by chadpitts, 10-14-2002 04:43 PM
    • Replies: 1
    • Views: 458
    10-14-2002 05:03 PM Go to last post
  16. All quiet on the western front


    Started by gnimelf, 03-24-2005 10:53 AM
    • Replies: 4
    • Views: 602
    03-25-2005 11:53 PM Go to last post
  17. almost there - need more advice though!!!

    Hi, I almost have my studio up and running. I thank you all for your advice and helping me get to where I am now. I have been reading and reading...

    Started by evance, 04-04-2005 09:55 PM
    • Replies: 7
    • Views: 704
    06-01-2005 01:57 PM Go to last post
  18. annoyance

    Hi all, i live in Miami and am a newbie. I use the HH withthe disposable canisters of MAPP gas. I bought them at Home Depot. I have two that are...

    Started by tesorosbeads, 06-05-2003 05:35 PM
    • Replies: 9
    • Views: 933
    06-06-2003 06:22 PM Go to last post
  19. another glitch from the gas company

    It must be me ... The gas company tell me that NFPA Code 54 will not allow me to bring in more than 2 psi propane into my home -- they said...

    Started by ljl561, 04-08-2003 01:51 PM
    4 Pages
    1 2 3 ... 4
    • Replies: 30
    • Views: 2,504
    05-01-2003 03:43 PM Go to last post
  20. Another Newbie Needs Help

    Yet another person who took a class and wants to set up a torch and kiln at home. I have dilligently read through all the safety posts about safey,...

    Started by Dilana, 11-09-2003 03:28 PM
    • Replies: 5
    • Views: 494
    11-10-2003 04:34 PM Go to last post

+ Post New Thread
Page 1 of 29 1 2 3 11 ... LastLast

Forum Information and Options

Users Browsing this Forum

There are currently 1 users browsing this forum. (0 members & 1 guests)

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 5 replies or 50 views
Hot thread with unread posts
More than 5 replies or 50 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts